Fike 10-063-1-R-1

Features

• Ten system status LEDs (AC Normal, Alarm, PreDischarge, Release, Supervisory, Trouble, Panel Silenced, Abort, Release Disabled, Ground Fault)
• General Alarm, Supervisory and Trouble relays
• Dip‐switch panel configuration
• Seven segment system status and diagnostic LED
• Local sounder (piezo) with distinct event tones
• Reset and Silence switches
• Disable switch for audible, releasing and relays (hardware disconnect)
• Alarm and Trouble silence resound (after 18 hrs.)
• Five selectable abort types
• Gentex or System Sensor sync protocol
• Twenty event history buffer
• Audibles selectable for slow, fast, continuous operation
• Integral 24 VDC power supply, 1A standby/4A alarm
• 120/240 VAC at 50/60 Hz power input
• Resettable and non‐resettable 24 VDC power output
• Battery and ground fault supervision
• 7 – 40 AH battery charging capacity
• Carbon steel enclosure, red or gray finish, 21”H x 14.35”W x 4”D, surface or flush mountable
• Lockable door with viewing window
• Enclosure can hold up to two 18 AH batteries
• Two Class B detect circuits capable of sequential, cross‐ zone, or single detector release operation.
• Maximum 25 detectors per detect circuit, 50 total.
• Detect circuits are compatible with select System Sensor or Hochiki conventional detectors and bases
• Detect circuits are compatible with linear heat detection cable or contact closure type devices
• Three Class B input circuits for monitoring closed contact devices
• Three Class B audible circuits for NAC devices, rated 2A per circuit
• Agent Release circuit, six ARMs/IRMs maximum, any combination
• Solenoid circuit, one 24V or two 12V solenoids. See Fike document 06‐186 for compatible devices.